ACTIVATED ALUMINA DESICANT 1/8_ 350LB STEEL DRUM – available on request

ACTIVATED ALUMINA DESICANT 1/8_ 350LB STEEL DRUM – available on request

Description

PRODUCT DESCRIPTION

Activated alumina is an aluminum oxide bead with an extremely porous structure and high surface area-to-mass ratio. Activated alumina has a wide variety of applications, including compressed air and gas drying.
In compressed air and gas drying applications, activated alumina will achieve dew points -40?F to -100?F, depending on the dryer design.
In compressed air desiccant dryers, a 1/8_ (2-5 mm) activated alumina bead is most commonly used. The _? (5-10 mm) activated alumina bead is typically used as a pre-bed for supporting large desiccant beds or as a buffer for silica gel beds. The 3/16_ (5-10 mm) bead is used when pressure drop and surface area requirements fall between the 1/8_ and _? material.
Features and Benefits

High adsorption capacity for reducing initial cost, energy consumption, and operating costs
Low abrasion for ensuring minimal dusting and a low pressure drop
Resistant to liquid water slugging resulting from the failure of up stream after-coolers, separators, or drain traps.
The adsorption capacity of the desiccant can be restored after complete regeneration.
High crush strength for limiting dusting during loading of desiccant into dryer towers
Uniform bead size minimizes pressure drop, channeling, and ensures utilization of the full desiccant bed
In regenerative drying systems, Van Air activated alumina beds are sized for a service life of 2-5 years
Available in 25lb pails, 50lb bags, 375lb steel drums and 2,000lb bulk bags